This was one of the most intense installs. This install required the insatllation of the TAG Predator MORLOCK board. This board is custom wired to the electronics of the individual marker.
The first task was replacing the stock board and custom fabricating a mounting bracket for inside the grip to allow the TAG board display to appropriately display through the display window at the bottom of the grip. You can see the TAG board glowing blue, as it is ready to fire.
Once the wiring was completed, which includes re-wiring the electrical path from the battery to the board and solenoid, we installed an on/off switch in the side of the marker. This is particularly difficult due to the electircal design of the marker and how the battery is grounded.
The body was milled and shapped as we fabricated custom eye covers. This particulat marker is equiped with the Level-10 bolt, however with the TAG board, breakbeam eyes are a standard. Since the ULE body is so thin, small and non obtrusive aluminum eye covers needed to be built and are attached via 4/40 screws. These are rounded and high polished as to match the elegance of this marker's anodizing finish.
